ABB ACQ580-34 User Manual

2 kHz, 4 kHz, 8 kHz (depends on the parameter settings)Switching frequency
Scalar control: 300 m (984 ft)Maximum recommended
motor cable length
Note: For restrictions due to EMC compatibility, see section EMC compliance
(IEC/EN 61800-3:2004) (page 179).
Longer motor cables cause a motor voltage decrease which limits the available
motor power. The decrease depends on the motor cable length and characteristics.
Contact ABB for more information. Note that a sine filter (optional) at the drive
output also causes a voltage decrease.
Control panel type
ACH-AP-H assistant control panel
Efficiency
Approximately 96.5% at nominal power level.
Energy efficiency data (EU ecodesign)
Energy efficiency data is not provided for the drive. The low-harmonic drives are exempt
from the EU ecodesign requirements (EU Regulation C/2019/2125).
Protection classes for module
IP00 (standard)Degrees of protection
(IEC/EN 60529)
IP20 (option +B051)
UL Type OpenEnclosure types
(UL 61800-5-1)
IIIOvervoltage category
(IEC/EN 60664-1)
IProtective class
(IEC/EN 61800-5-1)
Surrounding air conditions
Environmental limits for the drive are given below. The drive is to be used in a heated,
indoor, controlled environment.
TransportationStorageOperation
in the protective packagein the protective packageinstalled for stationary use
--For TN and TT neutral-
grounded network systems
and IT ungrounded net-
work systems: 0 to 4000 m
(13123 ft) above sea level
Installation site altitude
Above 1000 m [3281 ft]):
see When is derating ne-
cessary (page 167)
-40…+70 °C (-
40…+158 °F)
-40…+70 °C (-
40…+158 °F)
-15…+55 °C (5…131 °F).
No frost allowed. See
When is derating neces-
sary (page 167)
Surrounding air
temperature
176 Technical data

ABB ACQ580-34 Specifications

General

Brand	ABB
Model	ACQ580-34
Category	Control Unit
Language	English