ABB ACS380 Series User Manual

Parameters 103
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring the drive. 105
03 Input references Values of references received from various sources. 108
04 Warnings and faults Information on warnings and faults that occurred last. 109
05 Diagnostics Various run-time-type counters and measurements related to drive
maintenance.
109
06 Control and status words Drive control and status words. 111
07 System info Drive hardware and firmware information. 116
10 Standard DI, RO Configuration of digital inputs and relay outputs. 118
11 Standard DIO, FI, FO Configuration of the digital input/outputs. 121
12 Standard AI Configuration of standard analog inputs. 126
13 Standard AO Configuration of standard analog outputs. 131
15 I/O extension module Configuration of the I/O extension module. 135
19 Operation mode Selection of local and external control location sources and
operating modes.
139
20 Start/stop/direction Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
141
21 Start/stop mode Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings.
153
22 Speed reference selection Speed reference selection; motor potentiometer settings. 160
23 Speed reference ramp Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
171
24 Speed reference
conditioning
Speed error calculation; speed error window control configuration;
speed error step.
175
25 Speed control Speed controller settings. 175
26 Torque reference chain Settings for the torque reference chain. 180
28 Frequency reference chain Settings for the frequency reference chain. 184
30 Limits Drive operation limits. 195
31 Fault functions Configuration of external events; selection of behavior of the drive
upon fault situations.
200
32 Supervision Configuration of signal supervision functions 1…3. 206
34 Timed functions Configuration of the timed functions. 213
35 Motor thermal protection Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
219
36 Load analyzer Peak value and amplitude logger settings. 226
37 User load curve Settings for user load curve. 229
40 Process PID set 1 Parameter values for process PID control. 233
41 Process PID set 2 A second set of parameter values for process PID control. 244
43 Brake chopper Settings for the internal brake chopper. 246
44 Mechanical brake control
Configuration of mechanical brake control. 248
45 Energy efficiency Settings for the energy saving calculators. 252

ABB ACS380 Series Specifications

General

Brand	ABB
Model	ACS380 Series
Category	DC Drives
Language	English