ABB IRB 2600 Series User Manual

3.3.12 Inspecting Signal lamp (option)
Location of signal lamp
Signal lamp is an option.
Located as shown in the figure.
The figure shows IRB 2600 Standard.
A
B
C
D
xx0800000290
Signal lampA
R3.H1 +, R3.H2 -B
R2.CPC
R2.CSD
Required equipment
NoteEquipment
For spare parts no. see Spare parts - Spare
parts options in Product manual, spare
parts - IRB 2600.
Signal lamp
Content is defined in section Standard tools
on page 441.
Standard toolkit
These procedures include references to the
tools required.
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Inspecting signal lamp
Use this procedure to inspect the function of the signal lamp.
Note
If the signal lamp is damaged, it shall be replaced!
NoteAction
Check that the signal lamp is lit when motors
are put in operation ("MOTORS ON").
1
Continues on next page
146 Product manual - IRB 2600
3HAC035504-001 Revision: Q
© Copyright 2009-2018 ABB. All rights reserved.
3 Maintenance
3.3.12 Inspecting Signal lamp (option)

ABB IRB 2600 Series Specifications

General

Brand	ABB
Model	IRB 2600 Series
Category	Robotics
Language	English