Settings menu
When SETTINGS is selected from the three main sub-menus, the rst
screen for the password is displayed in the display.
The default password is “0000”.
This can be changed using the display buttons, always following the
same procedure:
• Use ENTER to scroll the digits (from left to right)
• Use ESC to return to the previous digit (from right to left)
• Press ESC several times to return to the previous menus
• Use DOWN to progressively scroll the numerical scale downwards
(from 9 to 0)
• Use UP to progressively scroll the numerical scale upwards (from 0 to 9)
After entering the password, press ENTER to access the information
gathered in this section:
Settings
Address
Display Set
Service
New PW
Time
Language
Vstart
DOWN
ENTER
Password 0000
ENTER
UP
1
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
2
3
4
5
6
7
8 *
Autotest
DOWN UP
9
Alarm
Remote ON/OFF
UV Prot. Time
Reactive power
MPPT
Power reduction
PMU RS485
DOWN UP
10
DOWN UP
DOWN UP
DOWN UP
DOWN UP
11
12
13
14
15
(*) Available for the Italian stand-
ard only. Refer to the section on
this topic in the manual.
To Next Page
Loading...
Need help?
General