To Next Page

To Previous Page

Publication 1763-RM001C-EN-P - October 2009

File Instructions 223

Addressing Modes and File Types are shown in the following table:

COP - Copy File

Instruction Type: output

The COP instruction copies blocks of data from one location into another.

CPW Instruction Valid Addressing Modes and File Types

For definitions of the terms used in this table see Using the Instruction Descriptions on page 4-2.

Parameter

Data Files Function Files

CS - Comms

IOS - I/O

DLS - Data Log

Address

Mode

(1)

Address Level

T, C, R

MG, PD

RI/RIX

PLS

RTC

HSC

PTO, PWM

STI

EII

BHI

MMI

LCD

Immediate

Direct

Indirect

Bit

Word

Long Word

Element

Source •• • •• • •••••••••• • ••

Destination •• • •• • •••••••

• ••

Length

•

(1) See Important note about indirect addressing.

IMPORTANT

You cannot use indirect addressing with: S, ST, MG, PD,

RTC, HSC, PTO, PWM, STI, EII, BHI, MMI, CS, IOS, and

DLS files.

COP

Copy File

Source #N7:0

Dest #N7:1

Length 1

COP

Execution Time for the COP Instruction

Controller When Rung Is:

True False

MicroLogix 1100 16.8 μs + 0.28 µs/word 0.9 μs

COP Instruction Valid Addressing Modes and File Types

For definitions of the terms used in this table see Using the Instruction Descriptions on page 82.