Atlas Copco FlexiROC T30 R Maintenance

FlexiROC T30 R 18 Water Mist System
129 No: 3629357835.1.3629419915 en-US
1.
Fill up the water mist tank.
2.
Turn off flushing air.
3.
Run the water mist pump at full speed for a few seconds so that the system fills up
with water.
18.5 Clean Filter in Water Mist Tank
Precondition
p
The water mist tank must be empty.
1.
Unscrew and remove the 6 bolts holding the cover (A) in place.
2.
Reach into the hole and slide the filter (B) off the water intake pipe and remove it from
inside the tank.
3.
Inspect and clean the filter. If the wire mesh is damaged, replace it with a new filter.
4.
Reach into the tank and push the filter back onto the water intake pipe.
5.
Refit the cover using the 6 bolts. Ensure that all washers and seals are correctly
placed.
6.
Fill up the water mist tank with clean water and check that the cover does not leak.

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English