SEWING AN EMBROIDERING PATTERN
142
Sewing Embroidery Patterns
Example: To embroider
a Embroidery color order
a
Thread the machine with thread for the first
color, pass the thread through the hole in
embroidery foot “U”, pull out some thread to
give it some slack, and then lightly hold the
end of the thread in your left hand.
b
Lower the presser foot, and then press the
“Start/Stop” button to start embroidering.
After 5 or 6 stitches are sewn, press the
“Start/Stop” button again to stop the
machine.
c
Trim off the excess thread at the beginning of
the stitching. If the thread is hidden under the
presser foot, raise the presser foot, and then
cut the thread.
d
Press the “Start/Stop” button again to start
embroidering.
→
When the area for the first color has been sewn, the
machine automatically trims the threads, then stops,
and the presser foot is automatically raised.
The next color in the embroidery color order moves
to the top.
e
Remove the thread for the first color from the
machine, and then thread the machine with
the thread for the second color.
f
Repeat these steps to embroider the
remaining colors.
→
After the last stitch is sewn, the message “Finished
sewing” appears. Press to return to the
previous screen.
* Depending on the pattern, a more attractive finish
can be achieved by trimming the thread jumps after
each color is embroidered.
g
When the pattern is finished, trim the excess
thread jumps (thread linking parts of the
pattern, etc.).
CAUTION
• If the thread is too tight, the needle may bend or
break.
a
To Next Page
Loading...
Need help?
General
