Brother Innov-is 2500D User Manual

CHANGING THE PRESSER FOOT
34
CHANGING THE PRESSER FOOT
Removing the Presser Foot
a
Press the “Needle Position” button to raise
the needle.
b
Press .
→ The screen changes, and all keys and operation
buttons are locked.
c
Raise the presser foot lever.
d
Press the black button on the presser foot
holder to remove the presser foot.
a Black button
b Presser foot holder
Attaching the Presser Foot
a
Place the presser foot under the holder,
aligning the pin on the foot with the notch in
the holder, and then lower the presser foot
lever so that the presser foot pin snaps into
the notch in the holder.
a Notch
b Pin
b
Press , or press in the
screen.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
c
Raise the presser foot lever.
CAUTION
• Always press in the operation panel before changing the presser foot. If is not pressed and the
“Start/Stop” button or another button is pressed, the machine will start and may cause injury.
• Always use the correct presser foot for the selected stitch pattern. If the wrong presser foot is used, the needle may
strike the presser foot and bend or break, and may cause injury.
• Only use presser feet made for this machine. Using other presser feet may lead to accident or injury.
a
b
a
b

Brother Innov-is 2500D Specifications

General

Built-in Embroidery Designs	136
Automatic Needle Threader	Yes
Thread Cutter	Automatic
USB Port	Yes
Maximum Sewing Speed	850 stitches per minute
Type	Sewing and Embroidery
LCD Screen	Yes
Bobbin Winding System	Automatic