Name: Canon EOS C300
Brand: Canon
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Preparing the Camcorder

Using a Tripod

The camcorder is shipped with the TB-1 Tripod Base for tripods with 0.95 cm (3/8 in.)

screws. You can mount the camcorder on a tripod but do not use tripods with mounting

screws longer than 5.5 mm (0.2 in.) as this may cause damage to the camcorder.

Using a Tripod with 0.64 cm (1/4 in.) Mounting

Screws

To use a tripod with 0.64 cm (1/4 in.) mounting screws, first

attach the supplied tripod adapter base to the camcorder and

then attach the tripod to the adapter base.

1 Remove the original TB-1 tripod base from the camcorder.

• Remove the 4 screws and then remove the base.

2 Attach the supplied tripod adapter base for 0.64 cm (1/4 in.)

tripods.

• Firmly screw in the 4 screws.

3 Attach the tripod.

• Firmly screw in the tripod screw.

Removing and Attaching the Grip Unit

The grip unit comes originally attached to the camcorder. You can remove it and replace it with the thumb rest

should the minimal configuration be necessary.

Removing the Grip Unit

1Set the Q switch to OFF.

2 Unscrew the grip unit’s lock screw and gently detach

the grip unit.

• The grip unit contains an internal connection cable

so be sure not to pull it too forcefully.

3 Disconnect the grip unit’s connection plug.

4 Screw the thumb rest onto the camcorder.

5.5 mm

COPY

Other manuals for Canon EOS C300

Questions and Answers:

Need help?

Do you have a question about the Canon EOS C300 and is the answer not in the manual?

General