Name: Canon EOS C300
Brand: Canon
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Setting the Time Code

Putting the Time Code Display on Hold

If you set an assignable button to [Time Code Hold] (A 111), you can press the button to freeze the display of

the time code*. While the time code display is put on hold, [H] will appear on the screen next to the time code

and [HOLD] will appear on the rear panel.

The time code continues to run normally while the time code display is on hold. When you resume the time code

display, the current time code will be displayed.

* The time code signal output from the HD/SD SDI terminal or TIME CODE terminal will not be put on hold. The time code

superimposed on the video signal output from the other terminals will be put on hold.

About the Time Code Display

An icon may appear next to the time code depending on the operation. Refer to the following table.

NOTES

•When [w Other Functions] > [24.00P] is set to [On] or [w Other Functions] > [Frame Rate] is set to

[23.98P], the frames value in the time code runs from 0 to 23. When [Frame Rate] is set to [25.00P], [50.00i] or

[50.00P], it runs from 0 to 24. For other [Frame Rate] settings, it runs from 0 to 29.

• When you are using interval recording, frame recording or slow & fast motion recording mode, you cannot

select the [Free Run] running mode. Conversely, when you are using pre-recording mode, [Free Run] is set

automatically and cannot be changed.

• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at

the point where the recording starts.

• As long as the built-in rechargeable lithium battery is charged and you selected the [Free Run] running mode,

the time code continues to run even if you disconnect all other power sources. However, this is less accurate

than when the camcorder is on.

• If you set an assignable button to [Time Code] (A 111), you can press the button to open the

[¤ TC/UB Setup] > [Time Code] submenu.

Icon Description

R The time code is set to [Regen.].

P The time code is set to [Preset] and the running mode is set to [Rec Run].

F The time code is set to [Preset] and the running mode is set to [Free Run].

E Time code signal is coming from an external source.

H Time code display is on hold.

No icon Time code during clip playback.

COPY

Other manuals for Canon EOS C300

Questions and Answers:

Need help?

Do you have a question about the Canon EOS C300 and is the answer not in the manual?

General