Transparency Interleaving
4-21
4
Special Copying and Mail Box Features
Transparency Interleaving
When coping onto transparencies loaded into the stack bypass, this mode enables you to
automatically add interleaving sheet of paper between each sheet of transparency that is
output. The interleaf sheets protect the copied surface of the transparencies. You can also set to
copy the content of the transparencies onto interleaf sheets.
IMPORTANT
•
The Transparency Interleaving mode cannot be used with the following mode(s).
- Copy: Finisher, Two-sided, Two-page Separation, Cover/Sheet Insertion, Image Combination, Image
Repeat, Mirror Image
•
Even if an optional finisher is attached, you cannot use any of the Finisher modes with the Transparency
Interleaving mode.
•
Only A4 is available for the Transparency Interleaving mode.
NOTE
•
The Transparency Interleaving mode is available for the Copying function only.
•
The machine's counter does not count blank interleaf sheets as copies.
•
Even if Tray Designation settings are set only for an output tray other than the main unit's output tray,
transparencies and sheet insertions are always output to the main unit's output tray. For instructions on
Tray Designation settings, see Chapter 4, "Customizing Settings," in the Reference Guide.
To Next Page
Loading...
Need help?
General
