Cisco CRS-1 - Carrier Routing System Router Troubleshooting Guide

9-199
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 9 Troubleshooting Memory
Watchdog System Monitor
SUMMARY STEPS
1. configure
2. watchdog memory threshold [location node-id] minor percentage-memory-available severe
percentage-memory-available critical percentage-memory-available
3. end
or
commit
4. exit
5. show watchdog [memory-state | threshold memory {configured | default}] [location node-id]
6. Contact Cisco Technical Support if the problem is not resolved.
DETAILED STEPS
Command or Action Purpose
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2
watchdog threshold memory [location node-id ]
minor
percentage-memory-available severe
percentage-memory-available critical
percentage- memory-available
Example:
RP/0/RP0/CPU0:router(config)# watchdog
threshold memory location 0/RP0/CPU0 minor 30
severe 20 critical 10
Configures the value of memory available for each alarm
threshold. For example, if the minor alarm threshold is set
to 30 percent, the severe alarm threshold is set to 20 percent,
and the critical alarm threshold is set to 10 percent, the node
goes into a minor memory alarm when the amount of
memory available falls below 30 percent of the total
memory on the card. In other words, this alarm occurs when
70 percent of the available memory is in use. The severe
memory alarm activates when the amount of memory
available falls below 20 percent, and the critical memory
alarm activates when the amount of memory available falls
below 10 percent.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English