Cisco RV 120W Administration Guide

Configuring Networking
Configuring IPv6
Cisco RV 120W Administration Guide 54
2
STEP 4 Click Save.
Configuring IPv6
The IPv6 configuration information for your router is performed in several sections
on your Cisco RV 120W. Make sure you do the following:
• Configure IPv6 WAN properties—See Configuring the WAN for an IPv6
Network, page 34.
• Set the Routing Mode to IPv4/IPv6 mode. See Configuring the Routing
Mode, page 54.
Configuring the Routing Mode
To configure IPv6 properties on the Cisco RV 120W, set the routing mode to IPv6:
STEP 1 Choose Networking > IPv6 > Routing Mode.
STEP 2 Select IPv4/IPv6 and click Save.
Configuring IPv6 Static Routing
You can configure static routes to direct packets to the destination network. A
static route is a pre-determined pathway that a packet must travel to reach a
specific host or network. Some ISPs require static routes to build your routing
table instead of using dynamic routing protocols. Static routes do not require CPU
resources to exchange routing information with a peer router. You can also use
static routes to reach peer routers that do not support dynamic routing protocols.
Static routes can be used together with dynamic routes. Be careful not to
introduce routing loops in your network.

Cisco RV 120W Specifications

General

Brand	Cisco
Model	RV 120W
Category	Network Router
Language	English