5-17
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Chapter 5 Managing Switch Stacks
Assigning Stack Member Information
Assigning Stack Member Information
These sections describe how to assign stack member information:
• Default Switch Stack Configuration, page 5-17
• Assigning a Stack Member Number, page 5-17 (optional)
• Setting the Stack Member Priority Value, page 5-18 (optional)
• Provisioning a New Member for a Switch Stack, page 5-18 (optional)
Default Switch Stack Configuration
Table 5-3 shows the default switch stack configuration.
Assigning a Stack Member Number
Note This task is available only from the stack master.
Stack master failure Remove (or power off) the stack master. Based on the factors described in the “Stack Master
Election and Re-Election” section on page 5-4, one
of the remaining stack members becomes the new
stack master. All other stack members in the stack
remain as stack members and do not reboot.
Add more than nine stack
members
1. Through their StackWise ports, connect
ten switches.
2. Power on all switches.
Two switches become stack masters. One stack
master has nine stack members. The other stack
master remains as a standalone switch.
Use the Mode button and port LEDs on the switches
to identify which switches are stack masters and
which switches belong to which stack master. For
information about using the Mode button and the
LEDs, refer to the hardware installation guide.
Table 5-2 Switch Stack Configuration Scenarios (continued)
Scenario Result
Table 5-3 Default Switch Stack Configuration
Feature Default Setting
Stack member number 1
Stack member priority value 1
Offline configuration The switch stack is not provisioned.
To Next Page
Loading...
Need help?
General