23-12
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Chapter 23 Configuring IGMP Snooping and MVR
Displaying IGMP Snooping Information
To re-enable IGMP report suppression, use the ip igmp snooping report-suppression global
configuration command.
Displaying IGMP Snooping Information
You can display IGMP snooping information for dynamically learned and statically configured router
ports and VLAN interfaces. You can also display MAC address multicast entries for a VLAN configured
for IGMP snooping.
To display IGMP snooping information, use one or more of the privileged EXEC commands in
Table 23-4.
For more information about the keywords and options in these commands, refer to the command
reference for this release.
Table 23-4 Commands for Displaying IGMP Snooping Information
Command Purpose
show ip igmp snooping [vlan vlan-id] Display the snooping configuration information for all VLANs on the
switch or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
show ip igmp snooping groups [count |dynamic
[count] | user [count]]
Display multicast table information for the switch or about a specific
parameter:
• count—Display the total number of entries for the specified
command options instead of the actual entries.
• dynamic—Display entries learned through IGMP snooping.
• user—Display only the user-configured multicast entries.
show ip igmp snooping groups vlan vlan-id
[ip_address | count | dynamic [count] |
user[count]]
Display multicast table information for a multicast VLAN or about a
specific parameter for the VLAN:
• count—Display the total number of entries for the specified
command options instead of the actual entries.
• dynamic—Display entries learned through IGMP snooping.
• ip_address—Display characteristics of the multicast group with the
specified group IP address.
• user—Display only the user-configured multicast entries.
show ip igmp snooping mrouter [vlan vlan-id] Display information on dynamically learned and manually configured
multicast router interfaces.
Note When you enable IGMP snooping, the switch automatically
learns the interface to which a multicast router is connected.
These are dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
show ip igmp snooping querier [vlan vlan-id] Display information about the IGMP version on an interface.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
To Next Page
Loading...
Need help?
General