show controllers fabric
To display fabric card information, use the show controllers fabric command in administration EXEC
mode.
show controllers fabric [clock| csc-fpga| fab-clk| fab-control| sca| xbar]
Syntax Description
(Optional) Displays which fabric clock each slot is synchronized to and whether
the clock is redundant or not.
clock
(Optional) Displays registers associated with the csc-fpga on each fabric card (FC).csc-fpga
(Optional) Displays registers associated with the fabric clock FPGA on all route
processors (RPs), line cards (LCs), and FCs.
fab-clk
(Optional) Displays the state of all RPs, LCs, and FCs in the chassis from a fabric
control software perspective.
fab-control
(Optional) Displays registers associated with Scheduler Control ASIC on the CSC
cards.
sca
(Optional) Displays registers associated with the Cross Bar (XBAR) ASIC on the
clock scheduler card (CSC) and switch fabric card (SFC).
xbar
Command Default
All fabric card information is displayed
Command Modes
Administration EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the show controllers fabric command to display various registers associated with the fabric cards and
state information associated with the fabric control software.
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
100 OL-30353-01
Fabric Management Commands
show controllers fabric
To Next Page
Loading...
Need help?
General
