Cisco XR 12000 User Manual

show netio idb
To display network input and output (Netio) interface descriptor block (IDB) information for an interface,
use the show netio idb command in EXEC mode.
show netio idb {interface-type interface-instance} [location node-id]
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
interface-type
Either a physical interface instance or a virtual interface instance as follows:
•
Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the modular services card or line card.
◦
module: Module number. A physical layer interface module (PLIM) is always
0.
◦
port: Physical port number of the interface.
In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RP0 or RP1)
and the module is CPU0. Example: interface MgmtEth0/RP1/CPU0/0.
Note
•
Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-instance
(Optional) Displays Netio IDB information for a specified node. The node-id argument
is entered in the rack/slot/module notation.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
Changed the interface-type interface-instance arguments to
required ones.
Release 3.8.0
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 5.1.x
60 OL-30353-01
Troubleshooting Commands
show netio idb

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English