A
B
146
III
The pneumatic suspension has an additional function
associated with it : the possibility to raise or lower the
height of the rear of the vehicle when stationary, in or-
der to facilitate loading / unloading of the boot.
TO INCREASE THE HEIGHT OF THE BOOT
SILL
- Press continuously at the top of the control A, which
is located in the boot, on the left-hand side.
This action will be accompanied by a sound signal.
You can stop the movement at any time by releasing
the control.
3 beeps will confirm that the movement has gone as far
as it can
.
To return to the nominal height :
- Press briefly twice at the bottom of the control
A.
TO DECREASE THE HEIGHT OF THE BOOT SILL
- Press continuously at the bottom of the control A.
This action will be accompanied by a sound signal.
You can stop the movement at any time by releasing
the control.
3 beeps will confirm that the movement has gone as
far as it can.
To return to the nominal height :
- Press briefly twice at the top of the control
A.
Note :
- If you start the vehicle without having returned it to
the nominal height, the automatic correction will ac-
tivate as soon as the vehicle starts to move. During
the correction, the SERVICE warning lamp lights up
and a message on the screen reminds you not to ex-
ceed 10 km/h (6 mph).
- The loading assistance does not function in the fol
-
lowing instances:
- If the button
B is lit up,
- in power economy mode.
-
When you first use the function, press for two seconds on
the control A to initialise the system. All subsequent ac-
tions will be followed immediately by the desired results
.
Driving with the boot sill in a low position may damage the components located under the bodyshell.
Grand C4 Picasso C4 Picasso
LOADING ASSISTANCE
To Next Page
Loading...
Need help?
General
