A
B
1
26
II
Your vehicle may be equipped with
an ANTI-INTRUSION ALARM.
This provides :
• Exterior perimeter protection by
means of detectors on the vehi-
cle access points (doors, boot,
bonnet) as well as on the electri-
cal supply.
• Interior volumetric protection
by means of ultrasonic sensors
(detecting movement inside the
passenger compartment). This
can be deactivated using the
control 1.
The installation also has a siren,
and a warning lamp on the control
1 which is visible from outside the
vehicle, indicating the three pos-
sible statuses of the alarm:
• Alarm not active (disarmed), warn-
ing lamp off.
• Alarm active (armed), the warn-
ing lamp flashes slowly.
• Alarm triggered (signalling an
intrusion), the warning lamp
flashes rapidly if the alarm is dis-
armed by a press on the control
B. It stops as soon as you switch
on the ignition.
Note : If there is a malfunction,
the warning lamp remains perma-
nently on.
DISARMING OF THE ALARM
USING THE REMOTE
CONTROL
The alarm is disarmed when you
unlock the vehicle (with a press on
button B on the remote control).
DISARMING OF THE ALARM
WITH THE KEY
Unlock the doors with the key.
The siren triggers. Enter the ve-
hicle, insert the key in the ignition
and turn it to the drive position to
stop the siren. Otherwise the si-
ren will continue for approximately
30 seconds.
ANTI-INTRUSION ALARM
To Next Page
Loading...
Need help?
General
