64
II
Park
Never select positions P or R if the vehicle is not
stationary.
If, while the vehicle is moving, position N is engaged
inadvertently, allow the engine to idle before engaging
position D or M.
Using the automatic
gearbox
This position of the selector
is used to prevent the vehicle
from moving when you are
stationary.
- To select position P, move the
selector back to the highest po-
sition (towards R), then push it
forwards and then to the left.
Reverse gear
Neutral
Starting the engine
1. To start the engine, the selector
has to be in position P or N.
2. Action the starter.
3. When the engine is running,
place the selector on R, D or
M as required.
4. Check, in the instrument panel,
the position engaged.
5. Release the brake pedal and
accelerate.
Note :
- If the selector is not in position P, a
message « place automatic gear-
box in position P » appears on the
multifunction screen, accompa-
nied by a beep and the flashing of
P in the instrument panel.
AUTOMATIC GEARBOX - GENERAL
- To avoid incoherence between
the position of the selector and
the actual position of the gear-
box, always exit from position P
when you switch on the ignition
and press the brake pedal.
Otherwise, when the ignition is
on or the engine is running :
1. Reposition the selector in
position P,
2. Put your foot on the brake
pedal and then select the
gear you want.
- To exit position P, move the se-
lector to the right and then to the
position you want.
- Only engage this position when
the vehicle is completely sta-
tionary. In this position, the front
wheels are locked. Make sure
that the selector is correctly po-
sitioned.
Only engage this position when
the vehicle is stationary. To pre-
vent snatching, do not accelerate
too soon after selection.
Never select position N if the vehi-
cle is moving.
To Next Page
Loading...
Need help?
General
