InteliLite Global Guide
149
8.1.1 Setpoints
What setpoints are:
Setpoints are analog, binary or special data objects which are used for adjusting the controller to the specific
environment. Setpoints are organized into groups according to their meaning. Setpoints can be adjusted from
the controller front panel, PC, MODBUS, etc.
All setpoints can be protected by a password against unauthorized changes. Password protection can be
assigned to the setpoints during the configuration procedure. See the chapter Password (page 66) in Operator
guide for instructions on how to enter and modify a password.
List of setpoint groups
Group: Basic settings 155
Group: Engine settings 164
Group: Generator settings 194
Group: General Analog Inputs 202
Group: Scheduler 262
Group: Geo-Fencing 283
Group: Plug-In Modules 287
Group: Sensors Spec 288
Group: Alternate Config 290
Group: CM-RS232-485 300
Group: CM-GPRS 302
Group: CM-4G-GPS 314
Group: CM-Ethernet 326
Group: EM-BIO8-EFCP 338
Group: PLC 340
For full list of setpoints go to the chapter List of setpoints (page 150).
To Next Page
Loading...
Need help?
General
