InteliLite Global Guide
7
ComAp reserves the right to update this End User's Guide /Manual at any time. ComAp does not assume any
responsibility for its use outside of the scope of the Standard Terms and the License Agreement.
Licensed End User is entitled to make only necessary number of copies of the End User's Guide /Manual. Any
translation of this End User's Guide /Manual without the prior written consent of ComAp is expressly prohibited!
Even if the prior written consent from ComAp is acquired, ComAp does not take any responsibility for the
content and quality of any such translation. ComAp will deem a translation equal to this End User's
Guide/Manual only if it agrees to verify such a translation. The terms and conditions of such verification must be
included in the written consent.
For more details relating to the Ownership, Extent of Permitted Reproductions Term of Use of the
Documentation and to the Confidentiality rules please review and comply with the ComAp’s END
USER or Distributor LICENSE AGREEMENT CONDITIONS– COMAP CONTROL SYSTEMS
SOFTWARE and STANDARD TERMS FOR SALE OF PRODUCTS AND PROVISION OF SERVICES
available on the www.comap.cz.
Used Open Source Software: mBed-TLS
https://www.mbed.com/en/development/software/mbed-tls/
http://www.apache.org/licenses/LICENSE-2.0
1.4 General warnings
1.4.1 Remote control and programing
Controller can be remotely controlled. In the event that maintenance of gen-set has to be done, or controller has
to be programmed, check the following points to ensure that the engine cannot be started or any other parts of
the system cannot be effected.
To be sure:
Disconnect remote control
Disconnected binary outputs
1.4.2 SW and HW versions compatibility
Be aware to use proper combination of SW and HW versions.
1.4.3 Dangerous voltage
In no case touch the terminals for voltage and current measurement!
Always connect grounding terminals!
In any case do not disconnect controller CT terminals!
1.4.4 Adjust the setpoints
All parameters are adjusted to their typical values. However the setpoints has to be checked and adjusted to
their real values before the first starting of the gen-set.
IMPORTANT: Wrong adjustment of setpoints can destroy the gen-set.
To Next Page
Loading...
Need help?
General
