ComAp InteliLite MRS16 User Manual

InteliLite Global Guide
74
5.4.22 Tier 4 Final 113
5.4.23 Alternate configuration 116
6 back to Controller setup
5.4.1 Start-stop sequence
State Condition of the transition Action Next state
Ready Start request
PRESTART (PAGE 506)
on
Prestart
Time (page 166)
counter started
Prestart
RPM > 2 or Oil pressure >
Starting
Oil Pressure (page 167)
or Generator
voltage > 10V or D+ voltage is
higher than 80%
Stop (Stop
fail)
OFF Mode selected or Shutdown
alarm active
Not Ready
Not Ready RPM < 2, Oil pressure not
detected, Generator voltage < 10V,
D+ not Active no shutdown alarm
active, other than OFF Mode
selected
Ready
Prestart Prestart time elapsed FUEL SOLENOID (PAGE 493) on,
STARTER (PAGE 510)
on,
Maximum
Cranking Time (page 165)
counter
started
Cranking
Cranking RPM > Starting RPM STARTER (PAGE 510) off, PRESTART
(PAGE 506) off
Starting
D+ input activated or oil pressure
detected or Generator voltage >
25% Nominal voltage
STARTER (PAGE 510) off, PRESTART
(PAGE 506) off
Cranking
Maximum Cranking Time (page
165)
, 1st attempt
STARTER (PAGE 510) off, FUEL
SOLENOID (PAGE 493) off, STOP
SOLENOID (PAGE 511)
on,
Cranking
Fail Pause (page 165)
timer started
Crank
pause
Maximum Cranking Time (page 165)
elapsed, last attempt
STARTER (PAGE 510) off, PRESTART
(PAGE 506) off
Shutdown
(Start fail)
Crank pause
Cranking Fail Pause (page 165)
elapsed
STARTER (PAGE 510) on, FUEL
SOLENOID (PAGE 493) on, STOP
SOLENOID (PAGE 511)
off,
Maximum
Cranking Time (page 165)
counter
started
Cranking
Starting
Idle Time (page 169)
elapsed
Minimal Stabilization Time (page 171)
and
Maximal Stabilization Time (page
172)
counter started
Running
any shutdown condition FUEL SOLENOID (PAGE 493) off, Shutdown

ComAp InteliLite MRS16 Specifications

General

Brand	ComAp
Model	InteliLite MRS16
Category	Controller
Language	English