CVT Drive and brake system
67
15. Once the cobra-head rod is loose, the drive con-
trol pedal shaft can be rotated and slipped off of
the brake pedal shaft. See Figure 6.29.
16. Inspect the pedal shaft components individually.
Replace any parts that are worn or damaged.
• The plastic bushings that fit between the two
pedal shafts should be replaced any time they
are removed. Lubricate them with a dry PTFE or
graphite-based lubricant on assembly. NOT
grease.
• Replace the push cap and all removed cotter
pins with new parts.
Figure 6.29
Drive control pedal shaft
Cobra head
Bushings
Brake pedal
shaft
17. Install the pedal shaft assembly by reversing the
steps used to remove it, then install the fenders.
NOTE: The pedal shaft support straps are two
different sizes. The smaller strap holds-up the
left (brake pedal) end of the pedal shaft assem-
bly. The larger strap holds-up the right (drive
control pedal) end of the pedal shaft assem-
bly. See Figure 6.30.
17a. Lubricate the points where the pedal shafts
meet the frame with a good quality lithium-
based grease. See Figure 6.31.
Figure 6.30
Left side strap Right side strap
Figure 6.31
To Next Page
Loading...
Need help?
General