D-Link DWL-2600AP Administrator's Guide

Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 44
January 2015
Section 4 - Managing the Access Point
Field Description
TSPEC Voice ACM
Limit
Specify an upper limit on the amount of trafc the AP attempts to transmit on the wireless
medium using a voice AC to gain access.
TSPEC Video ACM
Mode
Regulates mandatory admission control for the video access category. The options are:
•) On — A station is required to send a TSPEC request for bandwidth to the AP before
sending or receiving a video trafc stream. The AP responds with the result of the
request, which includes the allotted medium time if the TSPEC was admitted.
•) Off — A station can send and receive video priority trafc without requiring an admitted
TSPEC; the AP ignores video TSPEC requests from client stations.
TSPEC Video ACM
Limit
Specify an upper limit on the amount of trafc the AP attempts to transmit on the wireless
medium using a video AC to gain access.
TSPEC AP Inactivity
Timeout
Specify the amount of time for an AP to detect an downlink TS as idle before deleting it.
TSPEC Station
Inactivity Timeout
Specify the amount of time for an AP to detect an uplink TS as idle before deleting it.
TSPEC Legacy
WMM Queue Map
Mode
Select Enable to allow intermixing of legacy trafc on queues operating as ACM.
Table 19 - Radio Settings
Use the Radio page to congure both Radio One and Radio Two. The settings on the page apply only to the radio
that you choose from the Radio drop-down list. After you congure settings for one of the radios, click Apply and then
select and congure the other radio. Be sure to click Apply to apply the second set of conguration settings for the
other radio.
Conguring Radio and VAP Scheduler
The Radio and VAP scheduler is a standalone DWL-x600AP feature. To congure the Radio and VAP scheduler,
select the Scheduler tab in the Manage section. The Radio and VAP Scheduler allows you to congure a rule with a
specic time interval for VAPs or radios to be operational, thereby automating the enabling or disabling of the VAPs
and Radios.
One of the ways you can use this feature is to schedule radios to operate only during the ofce working hours in order
to achieve security and reduce power consumption. You can also use the Scheduler to allow access to VAPs for
wireless clients only during specic times of day.
Each rule species the start time, end time and day (or days) of the week the radio or VAP can be operational. The
rules are periodic in nature and are repeated every week.
A valid rule must contain all of the following parameters:
•) Days of the Week.
•) Start Time (hour and minutes).
•) End Time (hour and minutes).
Only valid rules are added to the prole. Up to 16 rules are grouped together to form a scheduling prole. Any two
periodic rules time entries belonging to the same prole must not overlap. The time granularity for the schedules is
one minute. The DWL-x600AP supports up to 16 proles.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm