User's Manual
238
Figure 5-197 SNMP
Step 2 Click to enable the function.
Step 3 Configure the parameters.
Table 5-60 SNMP parameters
Select the checkbox of SNMP version that you are using.
The default version is V3. There is a risk if you use V1 or V2.
Enter the monitoring port on the agent program.
Enter the read and write strings supported by the agent program.
Enter the destination address for the agent program to send the
Trap information.
Enter the destination port for the agent program to send the Trap
information.
Enter the username that is allowed to access the Device and has the
read-only permission.
Enter the username that is allowed to access the Device and has the
read and write permission.
To Next Page
Loading...
Need help?
General
