RA Indoor Unit SiBE18-821_C
184 Operation Manual
3.1.10 ON TIMER Operation
22
ON TIMER Operation
To use ON TIMER operation
• “ ” is displayed on the LCD.
• “ ” blinks.
• “ ” and day of the week disappear from the LCD.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press again.
Display
To cancel ON TIMER operation
Press .
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
In the following cases, set the timer again.
2.
Press until the time setting reaches the
point you like.
• “ ” and setting time are displayed on the LCD.
• The multi-monitor lamp blinks twice.
The TIMER lamp periodically lights orange.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
• “ ” and setting time disappear from the LCD.
• “ ” and day of the week are displayed on the LCD.
• Check that the clock is correct.
If not, set the clock to the present time.
1.
Press .
To Next Page
Loading...
Need help?
General
