CR805 Retransfer Card Printer Instrallation and Administrator’s Guide A-13
Load Laminator Overlay Material
Load the overlay material in one laminator cartridge at a time.
1. Unlock and open the laminator access door.
2. Remove the L1 (green) laminator cartridge
from the printer. Place the cartridge on a
smooth, level surface for loading.
3. Push the release latch (a) and open the gate
on the laminator cartridge (b).
The L1 (green) and L2 (orange) cartridges fit only in their assigned locations inside
the laminator. They are not interchangeable.
To Next Page
Loading...
Need help?
General
