CR805 Retransfer Card Printer Installation and Administrator’s Guide 33
Enable IPv6
Use the front panel Configuration menu to enable the IPv6 method used by your network.
1. Enter the menu system.
a. Press the U
SER button to suspend the printer.
b. Press E
NTER to enter the menu system.
c. Press the down arrow key until Configuration displays on
line 2.
d. Press E
NTER to enter the Configuration menu.
e. Press the down arrow to display Network IPv6 on line 2.
f. Press E
NTER to enter the Network IPv6 menu.
2. Set the IP Mode.
The IP Mode determines whether the printer uses IPv4-only
or both IPv4 and IPv6 addressing.
a. Press E
NTER to enter the IP Mode menu.
b. Press the down arrow to display DualStack on line 2.
Specifying DualStack allows the printer to use both IPv4
and IPv6 addresses.
The following example illustrates enabling a manual IPv6 address.
To Next Page
Loading...
Need help?
General
