A-18 CLM Laminator
The following laminator supplies are available. Most are available for a full card, smart card, or
magnetic stripe card.
Clear DuraGard®, 1.0 mil, up to 300 images/roll
Holographic DuraGard®, 1.0 mil, Random, up to 300 images/roll
Holographic DuraGard® Registered, 1.0 mil, up to 300 images/roll
Contact your authorized dealer for a complete list of available overlays.
Overlay Storage Guidelines
Store overlay material in the original package until you load it in the laminator. Keep the
original packaging closed until you are ready to use the overlay.
The overlay maintains its quality for about one year. For optimum card quality, purchase and
store quantities of material that can be used within one year.
Overlay material might require secure storage and tracking. Follow your organization’s policy
for storing and tracking the supplies used to make cards.
Store the overlay in a location away from direct sunlight, with a temperature between 50°
and 80°F (10° and 27°C). A range of 30% to 70% humidity is recommended.
Install supply rolls at room temperature. If supplies are stored in an environment that is
cooler than the printer environment, allow supplies to reach room temperature before you
use them.
If the printer will not be used for an extended period, remove supplies from the printer and
store them with new supplies.
To Next Page
Loading...
Need help?
General
