Figure 135. Plug in the power cord
3. For a DC power/cooling module, push the power cord plug into the connector until it snaps in place.
Verify the operation of a replacement part
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the faulted part.
3. From the Hardware card, select the view of the system where the part was replaced.
The status of the replacement part should read Healthy. If the status is still Faulted, wait a few minutes and refresh PowerStore
Manager. If the status does not change, ensure that the part is correctly seated, or contact your service provider.
Expansion enclosure service procedures
95
To Next Page
Loading...
Need help?
General