23
Rapid reading of alarms
The last alarm can even be displayed if the selector is not in the tenth diagnostic position or if the appliance
is in normal operating mode (for example when performing a wash programme):
→ Press the START/PAUSE button and the nearest option button simultaneously (as if you were entering
DIAGNOSTIC mode) for at least 2 seconds: the LCD display shows the last alarm.
→ The alarm continues to be displayed until a button is pressed.
→ During the time that the alarm is displayed, the appliance continues to perform the cycle or, if you are in
the programme selection phase, it retains the options selected previously in memory.
7.3 Deleting the last alarm
It is good practice to cancel the alarms stored:
after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle
after repairing the appliance, to check whether it re-occurs during testing
1. Enter the diagnostic mode.
2. Turn the selector dial clockwise until the eleventh LED is turned on (in the left-hand alarm reading row).
3. Press/touch the START/PAUSE button/sensor and the nearest option button/sensor
simultaneously (as shown in the figure).
4. Hold down the buttons until the LCD display shows “E00” (at least 5 seconds).
N.B. With this operation all the alarms stored are deleted.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
