Product Certifications
November 2016
Reference Manual
00809-0100-4804, Rev CB
114
Product Certifications
Special Condition for Safe Use (X):
1. The Rosemount 3051S/3051S-ERS Pressure Transmitter
contains aluminum and is considered to constitute a
potential risk of ignition by impact or friction. Care must be
taken into account during installation and use to prevent
impact and friction.
B.5 Canada
E6 CSA Explosionproof, Dust-Ignitionproof, and Division 2
Certificate: 1143113
Standards: CAN/CSA C22.2 No. 0-10, CSA Std C22.2 No.
25-1966, CSA Std C22.2 No. 30-M1986, CAN/CSA
C22.2 No. 94-M91, CSA Std C22.2 No.
142-M1987, CSA Std C22.2 No. 213-M1987,
ANSI/ISA 12.27.01-2003, CSA Std C22.2 No.
60529:05
Markings: Explosionproof Class I, Division 1, Groups B, C, D;
Dust-Ignitionproof Class II, Division 1, Groups E, F,
G; Class III; suitable for Class I, Zone 1, Group
IIB+H2, T5; suitable for Class I, Division 2, Groups
A, B, C, D; suitable for Class I, Zone 2, Group IIC,
T5; when connected per Rosemount drawing
03151-1013; Type 4x
I6 CSA Intrinsically Safe
Certificate: 1143113
Standards: CAN/CSA C22.2 No. 0-10, CSA Std C22.2 No.
30-M1986, CAN/CSA C22.2 No. 94-M91, CSA Std
C22.2 No. 142-M1987, CSA Std C22.2 No. 157-92,
ANSI/ISA 12.27.01-2003, CSA Std C22.2 No.
60529:05
Markings: Intrinsically Safe Class I, Division 1; suitable for
Class 1, Zone 0, IIC, T3C; when connected per
Rosemount drawing 03151-1016; Type 4x
IF CSA FISCO
Certificate: 1143113
Standards: CAN/CSA C22.2 No. 0-10, CSA Std C22.2 No.
30-M1986, CAN/CSA C22.2 No. 94-M91, CSA Std
C22.2 No. 142-M1987, CSA Std C22.2 No. 157-92,
ANSI/ISA 12.27.01-2003, CSA Std C22.2 No.
60529:05
Markings: FISCO Intrinsically Safe Class I, Division 1; suitable
for Class I, Zone 0; T3C; when installed per
Rosemount drawing 03151-1016 [3051S]
03151-1313 [ERS]; Type 4X
B.6 Europe
E1 ATEX Flameproof
Certificate: KEMA 00ATEX2143X
Standards: EN 60079-0:2012, EN 60079-1: 2007, EN
60079-26:2007 (3051SFx models with RTD are
certified to EN60079-0:2006)
Markings: II 1/2 G Ex d IIC T6…T4 Ga/Gb, T6(–60 °C
Ta
+70°C), T5/T4(–60 °C
Ta +80 °C)
Special Conditions for Safe Use (X):
1. The device contains a thin wall diaphragm. Installation,
maintenance and use shall take into account the
environmental conditions to which the diaphragm will be
subjected. The manufacturer’s instructions for installation
and maintenance shall be followed in detail to assure safety
during its expected lifetime.
2. For information on the dimensions of the flameproof joints
the manufacturer shall be contacted.
I1 ATEX Intrinsic Safety
Certificate: BAS01ATEX1303X
Standards: EN 60079-0: 2012, EN 60079-11: 2012
Markings: II 1G Ex ia IIC T4 Ga, T4(–60 °C
Ta +70 °C)
Special Conditions for Safe Use (X):
1. The Rosemount 3051S Transmitters fitted with transient
protection are not capable of withstanding the 500V test as
defined in Clause 6.3.13 of EN 60079-11:2012. This must be
taken into account during installation.
2. The terminal pins of the Rosemount 3051S SuperModule
must be provided with a degree of protection of at least IP20
in accordance with IEC/EN 60529.
3. The Rosemount 3051S enclosure may be made of aluminum
alloy and given a protective polyurethane paint finish;
however, care should be taken to protect it from impact or
abrasion if located in a zone 0 area.
IA ATEX FISCO
Certificate: BAS01ATEX1303X
Standards: EN 60079-0: 2012, EN 60079-11: 2012
Markings: II 1 G Ex ia IIC T4 Ga, T4(–60 °C
Ta +70 °C)
Temperature class Process temperature
T6 –60 °C to +70 °C
T5 –60 °C to +80 °C
T4 –60 °C to +120 °C
U
i
I
i
P
i
C
i
L
i
SuperModule
™
30V 300 mA 1.0 W 30 nF 0
3051S...A; 3051SF…A;
3051SAL…C
30V 300 mA 1.0 W 12 nF 0
3051S…F; 3051SF…F 30V 300 mA 1.3 W 0 0
3051S …A…M7, M8, or M9;
3051SF …A…M7, M8, or M9;
3051SAL…C… M7, M8, or M9
30V 300 mA 1.0 W 11.4nF 60 H
3051SAL or 3051SAM 30V 300 mA 1.0 W 11.4nF 33 H
3051SAL…M7, M8, or M9
3051SAM…M7, M8, or M9
30V 300 mA 1.0 W 11.4nF 93 H
RTD Option for 3051SF 5V 500 mA 0.63 W N/A N/A
To Next Page
Loading...
Need help?
General
