Section 8: Using the Epilog Legend Systems
90
Single Job Mode
If you press the "GO" key on the keyboard, you are telling the Legend that a job will
be coming from the host computer. To verify the state of the machine, look at the
Status bar across the bottom of the display. The display should indicate, "Ready". The
Legend will wait until the job arrives, and then run it. The name of the job will show
up at the bottom of the status bar.
Multiple Job Mode
If there are jobs in memory, select the "JOBS" menu heading and press the
“ENTER” key. The list of valid jobs in memory will drop down. Select the one you
want, and press, “ENTER”. This will give you the options of Run, Run Override,
View, or Delete. Select the one you want and press, “ENTER”. If you select Run,
the machine will begin processing that job. Press View to view the job on the display
panel. Delete will remove that job from memory. You cannot delete a job if it is
currently running.
You can load jobs at any time. If the machine is doing another job, it will save
anything sent during that job for later.
To Next Page
Loading...
Need help?
General
