49
Section 6: Using Your Legend
System Quick Setup
In This Section
¾ Artwork Setup
¾ Job Setup
Your Legend EX system is ready to use once you have followed the steps in
Sections 1 – 5. To get started quickly and run a sample piece of material on your
new Legend, the following is a very quick setup guide to describe the general
steps for running a first job. A detailed set of instructions for each step of the
process follows this quick setup guide:
1. Set up a simple piece of artwork in your software program (i.e.
CorelDRAW).
2. Turn on the power to your Legend and wait for a “Beep” to note the
machine is ready.
3. Turn on your exhaust.
4. Place your sample material on the table in the upper left corner (make sure
the table is low enough to accommodate the material).
5. Manually focus (or set Auto-Focus to “YES” when you print from the
Epilog print driver).
6. Close the door.
7. Go to FILE | PRINT. Make sure your Printer Destination is the “Legend
EX” and go to preferences and set the Speed, Power, etc, then “PRINT” the
page to your Legend.
8. Select JOBS on the Legend LCD Display Panel.
a) Press ENTER to show the jobs that are in the Legend print Queue.
b) Use the scroll arrows to highlight the job you want to print. Press ENTER
to select it.
c) Press ENTER one more time to run the job you have highlighted.
9. Alternate Printing Method –
If you want the job to start immediately upon
reception by the laser, press the GO button on the Legend keyboard before
printing the job. This step will allow you to bypass selecting the job from
the JOBS menu.
To Next Page
Loading...
Need help?
General
