Section 5: Configuring CorelDraw
44
Once “Calibrate colors for display” is deselected the Color Management fly out
will look like the following:
4. Click OK and that’s it. With “Calibrate colors for display” deselected you
will be able to Color Map vectors in Corel 9.
Installing and Using the Win Xp/2000 Ex
Print Driver with Corel 9
There is a possibility that installing the Legend print driver will cause raster
engraving errors when you print from Corel 9. Depending on how Corel 9 was
installed on your computer determines if the error will appear. A “Typical”
install of Corel 9 may cause the error depending on the version of Corel that was
installed. If you performed a “Custom” install, it is unlikely that you will see the
error. There is file that the “Typical” installation does not install onto your
computer that is automatically installed when a “Custom” install is performed.
You MUST reinstall Corel 9 if you have raster engraving errors when printing
from the Win XP/2000 driver or upgrade to Corel 10 or 11 .
The image below shows the raster engraving error that you will see. The error is
a series of dots that extend to the edge of the page that you are engraving.
To Next Page
Loading...
Need help?
General
