Section 1: Getting Started
10
The 220 volt cord that is supplied with the 120 watt laser has a NEMA L6-15R plug
(HUBBELL 4560 or equivalent). This is one of the most widely used 220 volt plug
styles within the United States and is known to all electricians and electrical hardware
suppliers.
Summary of Recommended Voltage:
LASER WATTAGE
THE US AND OTHER
COUNTRIES WHERE 110 IS
THE STANDARD ELECTRICAL
VOLTAGE.
COUNTRIES
WHERE 220 IS THE
STANDARD
ELECTRICAL
VOLTAGE.
30,35,40,45,60 110 volts 220 volts
75 110 volts or
220 for heavy-duty applications.
220 volts
120 220 volts 220 volts
The location of the power cord receptacle of the Legend is shown in the drawing
below, and is located on the left side of the machine near the back.
¾ Locate the power cord in the accessory kit. The end with the recessed terminals connects
to the Legend. Locate the power entry receptacle next to the “Power” label on the left
side of the machine. Insert the power cord firmly into the receptacle.
¾ Plug the machine into your wall power outlet, and turn the machine on. The power
switch is next to where the power cord connects to the Legend. Wait several moments for
the machine to beep and the carriage to move towards the upper left corner home
position. A diagram showing the location of the On/Off Switch and Power Cord
Receptacle for the EX and TT machines are located on the following pages.
To Next Page
Loading...
Need help?
General
