Section 1: Getting Started
4
6. Under the machine (all the way under), locate the ramps. They will be wrapped
in plastic. Remove them and place the metal hooks into the slots on the pallet.
These ramps will allow you to roll the machine off the pallet. There is a left
and a right ramp. The raised edges must be on the outside, not facing each
other.
7. Locate the four foam blocks supporting the machine on the pallet. These
blocks need to be pulled out. CAUTION is urged. These machines can weigh
in excess of 400 lbs. With a friend or two, lift one side of the machine just high
enough to remove two of the blocks. Do the same with the other side to remove
the remaining two blocks.
8. With a friend helping, carefully roll the machine off the pallet and down the
ramps. You may need to unlock the front casters before the machine will roll
freely.
9. Locate the accessory kit in the open compartment at the bottom front of the
engraver. Remove this box.
10. Open the main door to the engraver. Inside the cabinet, locate and remove two
5/8” diameter RED shipping locks. They are toward the front of the machine
and on either side of the X carriage. Turn the screw locks counterclockwise to
remove. Please save them. Also cut and remove the tie strap holding the lens
carriage in place.
Unpacking Your TT Machine
1. Cut and remove the strapping around the box and the plywood top. Remove the
plywood top.
2. Open the flaps and remove as much packing as you can. Please save this
packing material. This includes:
a) two foam top supports,
b) two foam bottom supports,
c) two empty cardboard box strengtheners one on the top and one on the bottom,
and
d) Two filled cardboard boxes for strength, one on the front and one on the back.
3. PLEASE do not throw away the box, you may need it later.
4. Locate the two foam supports on the top of the machine and remove them.
5. Locate the accessory kits in front of and behind the machine. Remove them.
6. With a friend helping, carefully lift the machine out of the box.
7. Open the main door to the engraver. Inside the cabinet, locate and remove two
5/8” diameter RED shipping locks. They are toward the front of the machine
and on either side of the X carriage. Turn the screw locks counterclockwise to
remove. Please save them. Also cut and remove the tie strap holding the lens
carriage in place.
To Next Page
Loading...
Need help?
General
