Section 9: Speed and Power
Recommendations
93
power setting to achieve the desired results. If the material is not moved between
passes the alignment of the second pass should be identical to the first pass.
Vector cutting may also require multiple passes. If you find that you cannot cut
completely through a material or if you are melting a material in a single pass, try
making two or even three passes instead of just one. Some materials are not laser
compatible, but can be cut anyway if a gentle touch is used. Some users like to
refocus between passes, but this is a matter of personal preference. Multiple passes
may also allow you to cut through thicker materials than the laser is rated for.
To Next Page
Loading...
Need help?
General
