Troubleshooting
101
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit
t
,
o
, operation indicators.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
Indicator status during an error/warning
: Lit : Flashing : Status maintained : Off
Indicators Status Remedy
(blue)/(orange)
High temp warning
You can continue projecting. If the temperature rises too
high again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there
is at least 20 cm between the wall and the projector's air
intake vent.
•
If the air filter is clogged, clean it. s p.113
(blue)/(orange)
High temp error
(overheating)
The internal temperature is too high.
•
The laser turns off automatically and projection stops.
When the fan has stopped, disconnect the power cord.
•
If the projector is installed next to a wall, make sure there
is at least 20 cm between the wall and the projector's air
intake vent.
•
If the air filter is clogged, clean it. s p.113
•
If turning the power back on does not clear the problem,
stop using the projector and remove the power plug
from the electrical outlet. Contact your local dealer or the
nearest Epson repair center.
s Epson Projector Contact
List
To Next Page
Loading...
Need help?
General
