Useful Functions
73
d
If projection does not start, press the button on the remote control to change the
source.
Make sure you point the remote control at the projector when using the button on the remote
control.
Projection starts.
e
When connecting two or more AV devices to the WirelessHD Transmitter, press the
button to switch images.
s
p.76
c
•
When receiving WirelessHD images, make sure WirelessHD is set to On from the Configuration menu.
s Settings - WirelessHD - WirelessHD p.91
•
Make sure you turn off the WirelessHD Transmitter if it is not going to be used for an extended period.
WirelessHD Settings Menu
a
Press the button, select
Settings - WirelessHD from the
Configuration menu, and then press
the
button to confirm the
selection.
The WirelessHD settings screen is
displayed.
b
Make settings for each of the
displayed functions.
Available functions on the WirelessHD settings menu
Function Explanation
Device Connections Displays a list of available WirelessHD devices that can be connected. The device names
and MAC addresses (device numbers) are displayed in the list. The MAC address is
displayed on the label on the base.
WirelessHD Enables or disables the WirelessHD function.
Reception Displays the reception for the image being projected.
WiHD Mode
Use Full for most situations. Full mode uses the maximum video bandwidth at all times.
Dynamic mode extends wireless ranges while optimally adjusting video bandwidth.
Set to Dynamic if the image is interrupted due to weak signals and other causes.
To Next Page
Loading...
Need help?
General
