Basic Operations
34
Keystone
You can use the button on the control panel to correct keystone distortion.
Move the
button up or down to display the adjustment gauges.
When the gauges are displayed, move the
button up or down to perform vertical correction.
When the top or bottom is too wide
c
•
The projected screen becomes smaller when correcting keystone distortion. Increase the projection
distance to fit the projected screen to the screen size.
•
You can make keystone settings from the Configuration menu. s Settings - Keystone p.91
•
You can make effective corrections within a projection angle of 30° top to bottom.
•
For position adjustment, you can maintain the quality of the projected image by performing correction
using lens shift. Use keystone when you cannot make adjustments using lens shift.
Switching the Source
You can change the source using the following method.
Press the button for the target port.
EH-LS10000 EH-LS9600W
c
•
You can also change the source by pressing the button on the control panel.
•
For video devices, start playback first and then change the source.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
s Settings - Input Signal - Video Signal/
Component p.91
To Next Page
Loading...
Need help?
General
