Troubleshooting
103
Indicator status during normal operation
: Lit : Flashing : Off
Indicators Status Remedy
Standby condition
When you press the button on the remote control, or the
button on the control panel, projection starts.
(blue)
Standby condition
(Standby Mode is set to
Communication On.)
When you press the button on the remote control, or the
button on the control panel, projection starts.
WirelessHD standby sta-
tus
When you start playback on the AV device connected to the
WirelessHD Transmitter, projection starts.
(blue)
Warm-up in progress
The power-off operation is disabled while the projector is
warming-up.
Cool-down in progress
All operations are disabled while the projector is cooling-
down. The projector enters standby condition when cool-
down is complete. If for any reason the power cord is discon-
nected during cool-down, wait until the projector has cooled
down sufficiently, reconnect the power cord, and then press
the
button on the remote control, or the button on
the control panel.
(blue)
Projection in progress
The projector is operating normally.
Standby condition
(Standby Mode is set to
Communication On.)
When you press the button on the remote control, or the
button on the control panel, projection starts.
c
•
Under normal operating conditions, the o and indicators are off.
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
s Settings - Operation - Illumination p.91
To Next Page
Loading...
Need help?
General
