Basic Operations
35
Aspect
You can change the input signal's type, aspect ratio, and resolution to match the Aspect of the projection
screen.
The available Aspect varies depending on the image signal currently being projected.
c
Note that using the aspect ratio function of the projector to reduce, enlarge, or split the projected
image for commercial purposes or for public viewing may infringe upon the rights of the copyright
holder of that image based on copyright law.
a
Press the button.
EH-LS10000 EH-LS9600W
c
You can make settings from the
Configuration menu.
s
Signal -
Aspect p.88
b
Use the buttons to
select the setting name, and then
press the
button to confirm the
selection.
c
Aspect may not be available
depending on the type of signal.
By normally selecting Auto, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Input Image Setting Name (Aspect)
Normal Full Zoom
4:3 images
16:9 images When projecting 16:9 images, Full and Zoom cannot
be selected.
Images recorded using
squeeze
Letterbox images
*
To Next Page
Loading...
Need help?
General
