Details of the Menu
The Media Setup Menu
The Media Setup menu can be accessed directly by pressing the M button.
indicates default settings.
Media Remaining
Item Parameter Explanation
Remaining Setup
On
Choose On to display and record, or Off to not display and not record, the
amount of media remaining. Length, Remaining Alert, and Print
Remaining Length options are available when On is selected. The display
panel shows the amount of media remaining based on the value selected
for Length and the amount of media used during printing.
Off
Length 1.0 to 999.5 m (3 to
3000 ft)
Enter a value for overall roll length between 1.0 and 999.5 m (3 to 3000 ft).
You can set in 0.5 m (1 ft) increments.
Remaining Alert 1 to 15 m (4 to 50 ft) An alert will be displayed if the amount of media remaining reaches this
length. Choose from values between 1 and 15 m (4 and 50 ft). You can set in
0.5 m (1 ft) increments.
Print Remaining Length Print
Use Print Remaining Length to print the amount of media remaining on
the current roll before replacing it with another type of media. You can
then enter this number as the media the length the next time the roll is
used.
Select Media
Parameter Explanation
RIP Settings Choose the media settings used for printing.
If RIP Settings is selected, the media settings selected in the software RIP
will be used. When printing without using the media settings registered in
the printer, select RIP Settings.
Select a number between 1 and 30 to use the settings in the
corresponding media setting bank.
To register a new setting or change a setting, use Customize Settings.
1 to 30 (media setting bank number)
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Using the Control Panel Menu
144
To Next Page
Loading...
Need help?
General