Epson SC-S70600 Series User Manual

G
Securely push the roll core holder into the roll
core using both hands, and then tighten the
fixing screws. Rotate the handle until part A in
the illustration below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll core holder. If part A is
still visible even after the handle has been
turned fully, rewind the handle. Then, loosen
the left roll core holder fixing screw, and
reattach the roll core.
For the subsequent steps, depending on how media is
rolled, see:
For information on taking-up with printed side out, see
U “Take-up with the Printed Side Facing Out” on
page 70.
For information on taking-up with printed side in, see
U “Take-up with the Printed Side Facing In” on
page 76.
Take-up with the Printed Side
Facing Out
A
Cut the paper tape approximately 60 cm in
length, and paste it approximately in the center of
the media using commercially available adhesive
tape.
B
Hold down the u button until the tip of the tape
reaches the center of the pipe.
C
Turn the paper tape over from the front of the roll
core, and stick using commercially available
adhesive tape.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
70

Epson SC-S70600 Series Specifications

General

Brand	Epson
Model	SC-S70600 Series
Category	Printer
Language	English