2.2. File
This section describes main functions of File.
2.2.1. Create New File
This function creates a new file of function code data.
Function selection tab
This tab displays the type of the
Inverter model selected.
FRENIC VG : VG1
FRENIC VG7 : VG7
Area Specification
You can select the specification by
area.
Currently, only J: JAPAN is
supported.
Inverter Capacity
You can select the inverter capacity
and voltage.
You can also open a list of function code data defaulted by the loader.
Therefore, you can edit the function code data even if the inverter is not connected to your PC
2.2.2. Open
This function reads a file of Function code data, Traceback data, Realtime trace data or
Historical trace data that has been already created and saved in your PC and opens the window
to edit the file data.
Open
This button opens the selected file.
File type
1) Function code data : [*.FN1] (VG1/VG7), [*.FNC] (VG7)
2) Traceback data : [*.TB1] (VG1)
3) Realtime trace data : [*.RT1] (VG1)
4) Historical trace data : [*.HT1] (VG1)
44
To Next Page
Loading...
Need help?
General
