5 Scan
284
Scan
5
îš„Auto Detect
Detects the document size automatically. The following table shows the document
sizes that can be detected automatically.
Note • If the document size cannot be detected automatically, a screen to enter the document size
appears.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
îš„Standard Size
Allows you to select from preset sizes.
îš„Variable Size
Allows you to enter the desired scan size when scanning a non-standard size
document or when scanning at a size different from the original document size. You can
specify a value in the range from 15 to 432 mm for the scan width (X), and a value in
the range from 15 to 297 mm for the scan length (Y), in 1 mm increments. The scales
attached on the upper and left edges of the document glass are helpful for you to
specify values.
Mixed Sized Originals (Scanning Different Size Documents
Simultaneously)
You can scan documents of various sizes simultaneously with the respective sizes or
with the same size. To use this feature, load the documents in the document feeder.
Important • When you select [Color] in [Color Scanning], and [2 Sided] in [2 Sided Scanning], set
[Resolution] to [400dpi] or lower.
• Always load A5 documents in portrait orientation.
• When loading B5 documents together with A3 documents loaded in landscape orientation or
A4 documents loaded in portrait orientation, load the B5 documents in portrait orientation.
• When loading documents, align the top left corners of the documents properly. Otherwise, a
paper jam may occur.
• The recommended document size combinations are A4 portrait and A3 landscape, or B5
portrait and B4 landscape. If another combination of document sizes is used, the documents
can be fed at an angle and may not be scanned properly.
Note • When you select [Enter Output Size] in [Reduce/Enlarge] and specify the output size in
[Output Size], the scanned data is automatically reduced/enlarged to the specified size.
However, since the scanned image is not rotated, the image will be reduced/enlarged to fit
the specified size while keeping its orientation. For example, when an A3 landscape original
is loaded and the output size is set to A4 portrait, the scanned image is reduced to A5
landscape and printed on A4 portrait paper.
• If the document size cannot be detected automatically, a screen to enter the document size
appears.
Document feeder Document glass
Auto-detectable
Document Sizes
B5, B5 , B4, A5, A5 , A4, A4 ,
A3, 8.5 x 11", 8.5 x 11" ,
11 x 17", 16K , 8K
B6, B5, B5 , B4, A6, A5, A5 ,
A4, A4 , A3
To Next Page
Loading...
Need help?
General
