Calling a Stored Program
325
Stored Programming
8
Calling a Stored Program
The following describes how to call a stored program.
When you call a specified stored program, the last screen shown when you registered
the stored program appears.
1 Press the <Services Home> button.
2 Select [Stored Programming].
3 Select a number of a stored program
containing the features you want to use.
Note • You can only select registered numbers.
• Select [ ] to return to the previous
screen or [ ] to move to the next screen.
• After the stored program has been called,
the machine sounds an audible tone. If a
failure occurs, the machine sounds a fault
tone.
For information on how to change the volume of the sound that notifies that a stored program has been
called, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming
Complete Tone" in the Administrator Guide.
4 After the stored program is called, select other features if necessary.
5 Press the <Start> button.
<Services Home> button
123
456
789
0#
C
<Start> button
To Next Page
Loading...
Need help?
General
