Connectivity & Network Setup
199
Tools
5
SNMP
îš„ Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
SIP
îš„ Port Status
Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.
îš„ Port Number
Enter a port number for use IP fax (SIP).
The default value is 5060.
Important •Do not use any numbers assigned to other ports.
Note • IP fax (SIP) is not available for some models.
FTP Client
îš„ Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive Mode] and [Active
Mode]. [Passive Mode] is selected by factory default. You can change the setting from CentreWare
Internet Services.
Receive E-mail
îš„ Port Status
Select [Enabled] when you receive e-mails or Internet faxes.
Send E-mail
îš„ Port Status
Select [Enabled] when you send e-mails or Internet faxes.
E-mail Notification Service
îš„ Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job and a direct fax
job by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status],
[Interlock Status], and [Fault Notice] are notified as the machine status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
Important •To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the internet. The communication fee shall be borne by you.
UPnP Discovery
îš„ Port Status
Select [Enabled] to use UPnP.
To Next Page
Loading...
Need help?
General
